PAPER HANDLING 2

5. Paper dusty and lots of paper powder

The paper is soiled by dust and powder used paper pieces can disturb the printing process. Dirt on the paper can contaminate the ink, blanket, plate and rollers conductor and eventually became dirty printouts anyway.

Therefore, before stacked on a table entry must be ensured paper in a clean state. The trick is to mengebas loose paper section by section until all the dust fall.

6. The paper stack too high

Accumulates printout on the table expenditure is too high may lead to set off. This is because the paper is on the top of the pile hit the bottom of the pile.

The fix is ​​to keep the pile is not too high, intermittently pile is taken and placed elsewhere. It could also put the plank intermediary legged in a pile so it does not press against each other.

7. Unmatching the type of paper and the type of ink compound

Paper coated eg Art Paper printed using ink that was supposed to non-coated paper, HVS example. As a result, too long time in ink drying process.

The fix is ​​to replace the ink that is appropriate to the type of the paper to be printed.

8. The paper quality is not good

Although both types of HVS, but due to different manufacturer's brands and sometimes the quality is not necessarily the same. When the paper against the ink absorption is not good, so the ink easily fade and easily uprooted or paper fiber, then the only way to resolve this problem  is to replace the better paper.

9. Mishandling the Paper

As a result of careless in bringing the paper, the paper can be wrinkled, crumpled and folded. The paper in this condition is difficult to repair. Paper that is wrinkled and dirty is not possible to print. We must replace the paper is still in good condition, not wrinkled and dirty.

How to bring a good paper is:

1. Keep the paper flat in a state of either horizontally or vertically, keep neat pile.

2. If the size is large and must be bent, then its bent should be in line with the paper and did not have until folded.

3. Do not be taken above the head or on the shoulders because the pile will not be maintained.

4. How to put it must be careful and not to be thrown.

5. Bring by the pallet better than simply by hand.